MMU2S Ikea Samla Filament Spool
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
As a cheap dry storage box for filament, IKEA Samla boxes (57x39x28 cm) are used by many.
- Rating
- 5 / 5
- Likes
- 178
- Downloads
- 1,142
- Makes
- 5
- Views
- 12,577
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
As a cheap dry storage box for filament, IKEA Samla boxes (57x39x28 cm) are used by many.
Sadly, when using a short piece of pipe to hold filaments, changing just one without disturbing the other three is very hard.
Each Samla box can hold up to 4 spools with 70mm width.
While the included filament spools from the MMU2S fit into the samla box, they are too wide so only 2 filaments fit in there.
This would mean a lot of wasted space since you now need 3x IKEA samla boxes or one huge one.
This print is the solution:
2 Filament Spools on Prusa MMU2S spools in the first Samla Box, and 3 in the 2nd one.
Print instructions
- Print 3x "spool roll bottom" and 6x "spool roll insert"
- Fit the ends of the rollers into skate bearing
- Push skate bearing assembly into place (will click into place)
- Insert M3 brass insert with soldering iron
- Connect three spool rolls into a big assembly
Upgrade:
- Add Caps to make the spools not slide off (and make it more beautiful)
- New designed rollers - print standing up with snug supports
- +5mm wider version - my 3DJake Spool is not really fitting the 75mm version
- Only 2x80mm spool holders fit, so combine it with 1x75mm