Ice Funnel for Hydroflask with Magnet Slot for Fridge (Separate Ice & Water Dispensers)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Thank you GarageMonkeySan for this well designed and practical tool! Check out my modificatio which is easier to print.
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 146
- Makes
- 2
- Views
- 1,269
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
Thank you GarageMonkeySan for this well designed and practical tool! The original, and this remix, are shaped for fridges that dispense water separate from the ice.
**If you have a combo Ice/Water dispenser, which many modern fridges do, I'd take a look at this design below, which I created from scratch to accommodate the combo water/ice dispenser. https://www.printables.com/model/213190-fridge-ice-funnel-magnitized-hydro-flask-other-for
Before printing the original, I figured I'd try and add the magnet slot to the design to make it more practical for use on the fridge ice dispenser. In the process I also re-oriented, so you print from the larger rectangular shaped face on the build surface (not the round face). This orientation also helps provide a little extra durability at the location where the funnel interfaces with the Hydroflask by avoiding paralleling build layers with the face of the bottle (aka, less likely to break after repetitive use).
I also added some material where the overhang was >65° so NO Supports are required.
I printed with 3 walls to improve durability and suggest ~40% infill for the few spots where the volume needs fill. Overall print time for me on an Ender 3 V2 was just shy of 7+30 hr.
The magnet slot is designed for the neodymium bar magnets with advertised dimensions of 60 x 10 x 3 mm, which you can find all over Amazon for about a buck each depending on quantity you buy. The goal is to make the magnet a "press fit", however depending on your printer tolerances, you may need to put a couple drops of CA glue to ensure it stays put.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.2mm layers (0.4mm nozzle)
Infill:
40%
Filament: Any PLA+ Any
Notes:
I'd suggest using a brim to ensure it holds to the build surface and doesn't lift up on the corners from uneven cooling.
If you have feedback for improvements, let me know I'll try and accommodate and update on my end.
Category: Kitchen & Dining