Adjustable Spool Holder .5kg - 2kg spools (fixed screw)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed spool holder by Asus1357 because of an STL error on screw. See description if your spool will fit.
- Rating
- 4.967 / 5
- Likes
- 144
- Downloads
- 767
- Makes
- 36
- Views
- 4,417
- Reviews
- 30
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Will fit spool width of 45mm-110mm (~ .5kg - 2kg spools)
Copied from original model by Copanko:
Necessary commercial parts
4 stainless steel “608” bearings.
These are the same as the spooler bearings that come with the Prusa MINI.
8 cap screws (M3-15 or M3-16)
8 nuts (M3)
Foam rubber sheet with adhesive on one side.
Recommended thickness: 2mm to 4mm.
Prepare four pieces cut to 16mmx14mm.
Affix these to the bottom of the spooler.
Notes on assembly
Each bearing holder has a specific mounting point. Please check the imprint on the printout.
Make sure that the C-ring is inserted in the correct direction. (Please refer to the attached figure.)
When inserting or disassembling the C-ring, be careful not to injure yourself as it may pop vigorously.
Install all bearings first, and then join the left and right frames together.
No rafts and supports are required for this printing.