Cat Ears for Logitech Headset
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.15 – €2.63 net (excluding VAT)
For file: CE3PRO_oreja gato casco.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.39 excluding VAT (range midpoint).
- Weight reported by the author
- 19 g
- Print time reported by the author
- 2.92 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A set of cat ears for your Logitech G432 headset and similar models.
- Rating
- 5 / 5
- Likes
- 68
- Downloads
- 284
- Makes
- 4
- Views
- 2,181
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Cosplay & Costumes in general
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
As the title says, these are cat ears for the Logitech G432 headset.
I don't know if they will fit other Logitech or other brand headsets. I specify the the critical dimensions of the model below:
The model has a 10 x 2 mm hole for it to be attached to the headset via some straps. The 10º angle is for the correct fitting in the middel part of the headset.
It is possible, that if your headset (other than the G432) has a similar headset radius, this model will work without problems.
For a complete set, you will need to print two of them, these being an identical of one another.
Print Settings
Printed in PLA, without supports or rafts, at 0.2 mm resolution and 20% infill.
Printing the parts is fairly straightforward, no need for supports or rafts.
Assembly
Once the ears were printed, to attach them to the headphones, I used some Velcro strips I had lying around, so I suppose that you can use cable ties or something similar.
The assembly detail can be seen in the second picture of the post and in the following two:
