Prusa MK3S noise cancelling tweaks
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I found 3 places where noise can come from on an i3 Mk3s. These are the pads I use to cancel the noise.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 26
- Makes
- 0
- Views
- 484
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Public Domain
I found 3 places from where vibration/noise comes from.
-one is the Y axis stepper, which is very close to the bottom plate, and at certain frequencies it starts to make noise.
The other two places are at the display.
-there is a small gap between the display and the cover
-the two circuit board can also wobble over each other
I printed these parts out of TPE with a 85A hardness, a very rubbery material. It is so soft that a Prusa I3 MK3S could not even handle it. I've never got through the initial layer before any trouble, unfortunately. I printed them on an Artillery Genius.