1 / 5
Washi Tape Dispenser
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tape dispenser for small washi tape rolls. Remix of the original design to use M3 screws and avoid supports.
- Rating
- 0 / 5
- Likes
- 57
- Downloads
- 182
- Makes
- 0
- Views
- 1,878
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
This is a remix of a design by Roxy2020 Washi Tape Dispenser by Roxy2020 - Thingiverse
I like the simplicity of the original design but it required lots of supports. To avoid this I sliced the model up and added some 12mm M3 screws.
This is designed to be self tapping, so tolerances of your machine are important. I found that I needed to run a 3mm drill bit through the left and right end pieces to clear out the holes.
I then cut a piece of 16mm dowel and hot glued the end caps on.