Artillery Biqu H2 mount with BLtouch for Volcano or normal hotend

This is a new mount for the Biqu H2 on any Artillery Sidewinder or Genius that I designed and tested with https://www.youtube.com/c/SolarityTechnology. There are two versions, one for the normal hotend, the other for a volcano hotend, which came with the stock extruder. It incorporates a Bltouch mount, the cables go through the back. It does not loose any printable area. It also has extra mounting holes unter the PCB for the Motor for even more rigidness, but it isn't necassery, it requires longer screws (M3x20). This new design also doesn't require to remove the V roller nuts. You can easily adjust the Z position of the probe pin with the top hex screw, it should be about 2mm above the nozzle. There are also versions vor the Sidewinder X2 and Genius Pro, but not with the stock leveling sensor. If someone gives me the the measurements, I'd be happy to modify it to work with the ABL sensors from Artillery

There is a dual fan duct in my account which I can recommend for volcano users

Bltouch offset:

x_offset:-2.5

y_offset:30

Some helpful Klipper config for the genius: (I was able to gain 6mm in X and 13mm in Y thanks to a 235x235 springsteel PEI sheet)

[stepper_x]

position_max: 226

[stepper_y]

position_max: 233

[extruder]

rotation_distance: 3.4334

[bed_screws]

screw1: 26,26

screw1_name: front left

screw2: 165,26

screw2_name: front right

screw3: 165,165

screw3_name: back right

screw4: 26,165

screw4_name: back left

[bltouch]

x_offset:-2.5

y_offset:30

[bed_mesh]

mesh_min: 10.5,40

mesh_max: 217.5,220

[screws_tilt_adjust]

screw1: 42,12

screw1_name: front left

screw2: 182,12

screw2_name: front right

screw3: 182,152

screw3_name: back right

screw4: 42,152

screw4_name: back left

speed: 50.0

screw_thread: CW-M5

Category: 3D Printer Extruders