Mini-Me Ender3 V2 Press Fit
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Update 09.14.22 Revised design to reduce hot end backpressure. Came down in weight a bit too!
- Rating
- 4.857 / 5
- Likes
- 71
- Downloads
- 585
- Makes
- 14
- Views
- 3,057
- Reviews
- 7
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
Remix of a remix here. The original design is the Mini-Me V4 Lightweight Ender 3 Hot End Duct. The MinionD Ender 3 Dual Duct was a remix of that design which made some nice improvements to the original design like thicker duct walls and a press fit design.
My remix builds off of both of those designs to enlarge the air inlets slightly as well as modifying the press fit region to fit an Ender 3 V2 cooling fan. I'm not sure if the stock fan on the V2 is the same as the stock Ender 3 but my fan didn't fit. So I changed that inlet size and adjusted my model so that it can be printed without supports. I also changed the side vent design to help reduce the hot end fan backpressure.
I prefer to use a support enforcer in PrusaSlicer to only print supports where the cooling fan presses in. Everywhere else should be fine. I've included a photo of where this should be located.
Other settings:
- 0.20 layer height
- Support with enforcers only
- Proto Pasta Carbon Fiber PETG