Lack Enclosure Threaded Filament Passthrough Guide (49mm-59mm Table thickness)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Threaded passthrough tube to feed filament from top of lack enclosure to the inside
- Rating
- 5 / 5
- Likes
- 28
- Downloads
- 132
- Makes
- 2
- Views
- 840
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Threaded two part filament guide designed to pass through the top of an IKEA Lack table.
Simply use a 1 inch hole saw to drill the hole for it to pass through, I had to shave the hole in the table a little bit with an exacto to make it fit since apparently 1 inch hole saws don't make 1 inch holes. But it was easy enough since the lack table is barely wood.
Fully closed distance is 49mm, Lack table top measured as 50mm. Would also work with any table top with thickness between 49mm to 59mm
Printed with thread side up for both
Tested and works, may need a small amount of sanding on male side for smoother action
Enjoy