Pool cleaner improvement - better suction
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.89 – €2.31 net (excluding VAT)
For file: 220306suctionguide_0.2mm_PLA_MK3S_2h15m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.10 excluding VAT (range midpoint).
- Weight reported by the author
- 23 g
- Print time reported by the author
- 2.26 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is an addition to a popular pool floor cleaner so that it cleans a broader part with each pass.
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 55
- Makes
- 1
- Views
- 462
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The cleaner attaches directly to your pool pump so it has good suction. However, as there is only one hole in the middle, it cleans only about 5 cm in with… with the rest you just make the dirt come up and dispense into the water.
Print this attachment and just slide it in the bottom. It focuses the suction so that the cleaner sucks up the dirt on nearly the whole width. I take less then half the time to clean the pool now.