Dollar Shave Club Razor Holder
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.15 – €3.85 net (excluding VAT)
For file: razorholder_015mm_pla_mk3smmu2s_4h7m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.50 excluding VAT (range midpoint).
- Weight reported by the author
- 31 g
- Print time reported by the author
- 4.11 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
I use Dollar Shave Club razors. In particular, I use their upgraded Executive razors/blades.
- Rating
- 5 / 5
- Likes
- 47
- Downloads
- 225
- Makes
- 1
- Views
- 1,294
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial
I use Dollar Shave Club razors. In particular, I use their upgraded Executive razors/blades. I finally got tired of them falling out of our soap dishes in the shower, so, I designed this dual razor holder that clips on to the shower pipe (US "standard" size which measures about 20.75mm in diameter). It snaps on easily and holds tight and doesn't freely rotate, which is nice.
~Mine is printed in black, which is super hard to photograph, so~ I'm attaching a Fusion 360 render. It works really, really well! And, as a bonus, it keeps our razors out of reach of our child who is tall enough to use the shower, but too short to reach these razors now =)
Print instructions
Category: Bathroom Print Settings
Printer Brand: Prusa
Printer: I3 MK3S
Rafts: No
Supports: Yes
Resolution: 0.2mm
Infill: 25%
Filament: Hatchbox PLA Black
Notes:
For additional strength, I set the number of perimeters to 4 and the top and bottom layers to 5 each.
Also, I used PLA. It should be noted that if you take really, really hot showers, you might consider switching this to PETG, ASA or ABS. The glass transition temperature of PLA is around 60°C, which happens to be the temperature of hot water heaters. Normally, you'd be mixing this down with cold water too, so, it shouldn't be an issue.
In my case, I have zero issues with PLA over showers that were a bit hotter than my taste.
You will have to use supports. I found them easy to remove, mostly in one piece on each sire, but I did have a little bit of work with the pliers to get it all off.