Panel Mount for 2.1 Channel Damgoo Amplifier
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I could not find hardware to panel mount this amplifier using the existing standoffs, so I created these to use instead.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 119
- Makes
- 0
- Views
- 545
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Since I was unable to find a way to use the existing hardware to panel mount this amplifier, I created these as an alternative.
The clips are designed to slide in from each side and wrap around the standoffs between the top and middle panels. You can use 4 clips - one in each corner, or you can replace the two rear clips with a cleat. The cleat attaches to your mounting surface and has a slot for the lower panel of the amplifier to slide into.
There are three options for each part:
- The standard version includes slots for an M4 square nut and is intended to be attached to the panel from behind.
- The “Top Mount” version has no slots and can be used with any top-mounted M4 hardware.
- The “Countersink” version is also for top-mounting but includes a countersink for your aesthetic pleasure ;-)
The parts should all print without supports - 0.2mm layer height is what I used. Print the clips with the long side facing down. The parts are small, so the bridging required should not be a problem. The cleat should be printed with the slot facing up.