ShellStrike DS-6 Spring Spacer and Reinforcements
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Spring Spacer for the Nerf ShellStrike DS-6 Blaster prints in two halves so you can install them into the plunger head…
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 24
- Makes
- 0
- Views
- 300
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution
- Spring Spacer for the Nerf ShellStrike DS-6 Blaster
prints in two halves so you can install them into the plunger head without removing the plunger rod. (see photo, yellow spacer)
In theory, there is still more room for spring compression; but I didn't want to risk it. The DS-6 has a weak plunger rod. If you want to experiment with z-scaling the spacer; in theory it could be up to 12mm tall. (current file is 8mm)
-DANGER: the DS-6 blaster has a weak plunger rod; people have already broken theirs by using Upgraded Springs.
a Spacer is by no means as strong as an Upgrade Spring, but the risk is still there.
- Spring Stop Plate Reinforcement
This plate reinforces the thin internal shell wall that the spring rests against.
- Priming Reinforcement
These small tabs insert into the priming handle to (theoretically) increase the surface area that engages the priming rod; to reduce the odds of breaking it.
(epoxy recommended)
Category: Toys & Games