FrontFishingRodRack
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The Front Fishing Rod Rack is intended to be used with the Rear Fishing Rod Rack. The set of assemblies allow the user…
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 30
- Makes
- 0
- Views
- 283
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
The Front Fishing Rod Rack is intended to be used with the Rear Fishing Rod Rack. The set of assemblies allow the user to mount fishing rods on their Tesla roof rack. The Fusion 360 file lists all additional hardware needed to use the racks. All steel hardware is recommended to be 316 stainless steel to prevent rust. All parts were printed using PETG except the ClampPads. These were printed using NinjaFlex. The two vertical holes and the horizontal slot on the opposite side were made for a bit of bungee/shock cord. Feed the ends down through the vertical holes and tie a simple knot in them. Then stretch the cord across the mounted fishing rods and hook it into the channel on the opposite side. With the rods between the bumps and tied down by the cord, they will not move at all.
Print Settings
Printer:
TrueUpLZ
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20
Filament:
Atomic Filament PETG PRO
Jet Black
Notes:
I used 5 vertical shells and 5 top/bottom shells in PrusaSlicer. The M8 threads in the RodClamp should be cleaned up using a tap to yield smooth operation of the RodHolderKnob for tightening the clamp.
Category: Sport & Outdoors