Easy-mount Drybox for Prusa Printer Enclosure V2
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.39 – €0.48 net (excluding VAT)
For file: knob_exit_015mm_pla_mk3smmu2s_31m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.44 excluding VAT (range midpoint).
- Weight reported by the author
- 4 g
- Print time reported by the author
- 30.6 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a remix of the Standalone Drybox for Prusa Printer Enclosure V2.
- Rating
- 5 / 5
- Likes
- 26
- Downloads
- 198
- Makes
- 1
- Views
- 2,646
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This is a remix of the Standalone Drybox for Prusa Printer Enclosure V2. I added a cleat mounting system and a PTFE mount for the filament exit. Parts:
- Base - the drybox base, with a hole in the back (instead of the slit) and a slot on the front to hook onto the cleat.
- Lid - the lid, unmodified from the original
- Cleat - the piece that mounts on the enclosure, that the base hooks onto
- Knob - the knob, unmodified from the original
- (Filament) Exit - the insert that goes into the back of the base, for mounting a PTFE tube in
The filament exit is build for a 4mm OD tube. The Fusion 360 model (f3d) is parameterized to make that easier to change.
The large desicant tray will no longer fit. I found it rather cumbersome, so I use permeable cloth bags (Amazon) instead. Note, when using bags with drawstrings, you must wrap the drawstring up around the opening and tuck it under. Otherwise, the drawstring may get caught up in the spool and bind it.
Print instructions
The cleats must be printed vertically. Printing them in any other orientation would require supports and compromise their strength.
I had good results printing the base and the lid at 0.3mm from PLA, with the enclosure doors closed, with no supports. With the doors open (as is recommended for PLA), I had issues with minor warping. With them closed, I had no issues, though the overhangs were slightly worse, and I trimmed off a few loose threads.