Peak Design Mobile Continuity Camera Mount for Apple Studio Display
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.01 – €3.67 net (excluding VAT)
For file: Studio Display PD Mobile Continuity Camera Adapter_0.15mm_PLA_MINI_3h34m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.34 excluding VAT (range midpoint).
- Weight reported by the author
- 37 g
- Print time reported by the author
- 3.57 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Magnetically mount an iPhone in a Peak Design Mobile Case on an Apple Studio Display for Continuity Camera
- Rating
- 5 / 5
- Likes
- 23
- Downloads
- 88
- Makes
- 1
- Views
- 2,411
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
A magnetic mount to adapt Peak Design's Mobile Case to an Apple Studio Display for use with Reincubate Camo or macOS Ventura's forthcoming Continuity Camera feature.
Requires 4x 10mm x 3mm refrigerator magnets and a suitable pause at the appropriate layer to embed them in the print.
I recommend you use Peak Design's Mobile case and retain the small square boss on the phone side of this adapter – this will make the magnet joint much stronger by preventing sliding in any direction. This should also be compatible with MagSafe natively without a Peak Design case if you remove the boss from the center of the mount, but I haven't tested it.
My first print so far (GCODE available here) with this design was with:
- Prusament PLA Galaxy Silver
- 0.15mm layers, QUALITY preset in Prusa Slicer
- 4 perimeters
- 15% gyroid infill
- supports only on the Studio Display clamp/rail
- printed with the broadest flat side (faces you on the mount) down on the plate