Corgi Phone Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Let a corgi hold your phone while it charges!
- Rating
- 5 / 5
- Likes
- 94
- Downloads
- 799
- Makes
- 8
- Views
- 4,034
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial
General
Inspired by a few of the phone stands available out there I wanted one that I can easily grab my phone off of, with or without a charging cable attached but had some uniqueness factor to it. Corgis are cool and so with this available model, I was able to come up with this phone stand.
Use either double sided tape or nano suction adhesive (what I recommend) to keep it on your desk.
Phone Stand Properties
- Larger openings to support bulkier cases or larger phones
- Extra back support should allow for portrait and landscape orientation
- Extra gap from where the phone stands to the base should allow for larger sized charging cables
Printing
I printed this on a 0.4mm nozzle using PLA at 0.2mm layer height. I used a standard cubic infill at 15% and it feels pretty solid.
There's two ways you can print this in regards to overhangs, you can either add supports OR (what I recommend) use the Cura Experimental option Make Overhang Printable. I used the default settings for it but you can mess with the overhang angle setting to get your desired outcome. While it changes the model a little bit, you don't really notice the changes (specifically under the ears, by the tongue and the tail) and you'll save some filament not printing supports.