Serpentor (Slinky)

About the Model

This is a remix of the Serpentor Model as a springy slinky. It's easy to print with no support
(See the Printer settings I used below)

Why I made this model

As soon as I saw Joel Tellings the competition to remix the Serpentor Model I instantly came up with 5 ideas some rather strange.  I now have more than 50 remix ideas of the Serpentor Model planned and hope to make and publish some of them over the next 2 weeks before the competition closes. So stay turned for Fidget Toys, Games, Educational gadgets, Sculptures, Illusions and more strange remixes 

When I printed this model 30 minutes before the end of the print I have a power cut so I ended up with a headless Serpento Slinky. If stead of through the print into the failed print pile I used my bendy logic and removed the infill to turn it into an apple pencil holder which work really well. So if you use your imagination failed prints can sometimes be repurposed for other uses

So this is my 1st and 2nd entry into the competition 

Tiktok video Competition Entry 1 - Apple pencil holder (The failed version) https://www.tiktok.com/@themadrobot/video/7109924596174081286?is_from_webapp=1&sender_device=pc&web_id=7007511511506994694

TikTok Video Competition Entry 2 - Serpentor slink.
(Video coming soon)

Printer settings

(Note: Both files use the same setting)

Supports: None
Rafting: None

Infill:10%
Layer height:0.3mm

Filament: PLA

Print time

Slinky = 9hrs 4mins
Base = 1hr

Post process

After it is printer use a spatula  to slipt the slinky ming in a spiral starting from the bottom to the top of the model