1 / 7
SuperMicro CSE-846 Fan Hotswap Holder FAN-0127L4 — image 1
1 / 7

SuperMicro CSE-846 Fan Hotswap Holder FAN-0127L4

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fits a standard 80mm computer fan into the middle chassis fan slots in a SuperMicro CSE-846

Rating
0 / 5
Likes
15
Downloads
98
Makes
0
Views
1,286
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution

This design fits a standard 80mm computer fan into the middle chassis fan slots in a SuperMicro CSE-846. I designed this so I could replace the case's loud factory fans (part number FAN-0127L4). Note that the fan can be oriented either way if you would rather blow air towards the front of the case.

Your 80mm fan's center-most 4-pin guide rail will need to be clipped so that it fits in the case's hot swap 4-pin slot. I then recommend folding the excess fan cable into the design's top clip. Refer to pictures for which guide rail to remove from your 80mm fan and how I folded the excess cable. The process is identical even if you orient the fan to blow towards the back of the case.

You may note that there is no snap-in clip forcing the holder in-place like the FAN-0127L4 has. This is for two reasons: 1) it did not seem necessary as the design is kept in place with friction from the sides and 4-pin alone and 2) there was no way to design the snap-in clip that would allow it to be printed without supports.

I designed this part so that it can be printed without supports. I printed it at 100% infill but I assume 20% would also work.

I'm also including two pictures of how I replaced the back-of-chassis 80mm fans in part number FAN-0125L4. You simply unscrew and replace the fan, then remove the retaining bracket holding in the 4-pin. A dab of hot glue to keep the 4-pin in place and a zip tie to tie off the excess cable helps a lot.

Tags