E-Steps Calibration Helper-Tool
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.83 – €2.23 net (excluding VAT)
For file: Prusa Generic PLA_v2_0.2mm_PLA_MK3S_2h43m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.03 excluding VAT (range midpoint).
- Weight reported by the author
- 11 g
- Print time reported by the author
- 2.72 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a small tool to help set the filament feed or also called E-Steps on a direct extruder.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 43
- Makes
- 0
- Views
- 489
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
This is a small tool to help set the filament feed or also called E-Steps on a direct extruder.
Yes, you can cut the filament to length with other tools, but I like it more elaborate. And the filament is straightened in the process, which allows for more accurate measurement!
It cuts the filament 1.75mm to the exact length of 120mm from the extruder entrance. See picture below.
The length of the groove is equal to the 120mm.
The small insertion serves to measure the remaining piece, inserted in the hole, relatively straight with the caliper.
The procedure how to enter a defined filament feed of 100mm with Pronterface or octoprint via Gcode and the calculation method can be watched on the internet or on Youtube.
Both parts are printed upright on the print bed. So you don't need any supports and the holes will be nice and round.
