Coaster Waterer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Description
Condensation from your cold cup runs down the cup into the funnel and then runs down the three pipes also used as stakes to make sure your plant is being watered well!
I used ABS for this but PLA might be to brittle for the long stakes, PLA+, and PETG will be the easiest to print with, and be strong in the end.
I printed at 15% infill but you might want to go lower to take less time.
Used 0.2 layer height.
Support may be needed for the poles if you have a less calibrated printer.
Useage
simply put the coaster in until it is sturdy enough for your liking, small succulents work best as they don't tickle the bottom of your coaster! If you have stiffer soil, try sanding a tip at the end of the poles to act as a small knife, be careful as the poles are very brittle. Enjoy!