Coasters With Changeable Designs
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These coasters are created with a 2-part container that screws together to display flat discs.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 44
- Makes
- 0
- Views
- 271
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
This is a resizing of previous models to create coasters. These coasters are created with a 2-part container that screws together to display flat discs. The container was originally for an extruder visualizer: https://www.printables.com/model/197272-pogs-and-car-wheels-extruder-visualizer
Some of the discs, car wheel hubs, are from the same model and can be printed on any printer. The other discs are from several models of POGs and Slammers intended for a printer with an MMU: https://www.printables.com/social/132782-gdownton/collections/183413
Everything is printed without supports at 0.2 mm and 15% infill. The POGs are printed design side down for a smoother finish.
Container tops and bottoms are sized up from the original by a factor of 266 in all xyz directions.
POGs and wheel hubs are sized up as follows to get a good fit in the containers: x-273, y-273 z-266.
POG Slammers are sized up/down as follows: x-264, y-264, z-58.
All the models and prints included with this model are sized appropriately.