Water Tight Fully 3D Printed Bottle - The MakerBottle - (Vase Mode)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This was a proof of concept to make a fully 3D printed water bottle!
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 198
- Makes
- 0
- Views
- 2,057
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other 3D Objects for Learning
- License
- Creative Commons — Attribution
IMPORTANT:
You must use these settings in order to make this bottle work properly and be completely watertight.
You must print the ‘MAKERBOTTLE’ file in PETG filament
- Nozzle Temp:~240C
- Bed Temp:~80C
- Line Width:0.8mm
- Layer Hight:0.2
- Speed:35mm/s
- Set to Spiralize outer contour/Vase mode
You must Print the ‘TPU CAP’ in TPU filament
- Nozzle Temp:~220C
- Bed Temp:~60C
- Line Width:0.4mm
- Layer Hight:0.2
- Speed:35mm/s
- Set to Spiralize outer contour/Vase mode
Notes:
-The TPU Cap is made with what I like to call “Negative Tolerance” where it is slightly smaller than the diameter of the bottle throat, giving it a friendly squeeze on the bottle to keep it watertight even upside down! Scale up or down slightly to get it perfect for your printer.
-Settings can be changed to fit your individual needs but I do recommend them for the best results
-Please share your prints!