USPSA/IPSC Adjustable Magazine Carriers
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adjustable magazine carriers for USPSA/IPSC belt rigs. Mounting to a TekLok-compatible clip (consider the PipClip,…
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 90
- Makes
- 0
- Views
- 1,518
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
Adjustable magazine carriers for USPSA/IPSC belt rigs. Mounting to a TekLok-compatible clip (consider the PipClip, also in my designs, for a printable option), they can be adjusted for camber and toe, to allow tuning of wrist and arm angle across your entire belt.
Supports bullets out as well as left- and right-hand bullets forward.
Comes with five sizes of pouch for common sizes of magazine:
- Single Stack: single-stack 1911 magazines. Inside dimensions 13mm×35.25mm.
- Small: Beretta 92/CZ-75 size. Inside dimensions: 21mm×32mm.
- Medium: CZ P-09 size. Inside dimensions: 22mm×32.5mm.
- Large: Glock size. Inside dimensions: 23mm×33.5mm.
- XL: double-stack 1911 magazines. Inside dimensions: 23mm×35.25mm.
For best fit, measure your magazines, print the next largest pouch, and use a screw through the front of the pouch to adjust retention to your preference.
Assemble using M3x25 cap screws and nuts.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2mm layers, 0.4mm nozzle
Infill:
60% cubic
Filament:
eSun PLA+
Notes:
Print belt plate laying flat.
Hardware
Press the body and belt plate hinges together. Run a 30mm M3 cap head screw through them, adjust, and tighten down against a nut in the captive pocket.
If extra retention is needed, run another 30mm M3 bolt through the clamp at the magazine pouch's opening and tighten until sufficient retention is attained.Category: Sport & Outdoors