1 / 3
Satsana Micro Swiss Direct Drive Fan Duct for CR-10S Pro V2 — image 1
1 / 3

Satsana Micro Swiss Direct Drive Fan Duct for CR-10S Pro V2

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fan ducts for Micro Swiss Direct Drive in both 4-fin and 5-fin hot end variants

Rating
0 / 5
Likes
13
Downloads
181
Makes
3
Views
1,713
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

was flabbergasted that despite the multitude of various fan ducts floating around Thingiverse, NONE of them seemed designed for the CR-10S Pro V2 and Micro Swiss.

This duct is designed for:

CR-10S Pro V2
BLTouch Sensor
Stock fans
Micro Swiss Direct Extrude***

*** Note on the Micro Swiss: I purchased the M2601 version, linked here: https://store.micro-swiss.com/products/micro-swiss-direct-drive-extruder?variant=31316019773507 has a 4-fin hot end. I am now aware (after purchase) that you can buy the M2602 extruder-only version without the hot end, then buy the https://store.micro-swiss.com/collections/cr-10s-pro-v2/products/all-metal-hotend-kit-for-cr-10-pro 5-fin hot end. Fan ducts for both versions are attached.

I have not verified the 5-fin hot end on my build but it's based on the length difference between the 4- and 5-fins as verified by Micro Swiss.

Use M3 screws and 2x M3 nuts to attach (I made a version with captive nuts, but found that with 3x walls you can essentially self-tap with the screws). I added a ziptie location for the cables (break off the designed-in support), modified a ton of tolerances, got the fan ducts adjusted to the proper height with the nozzle, made a permanent BLTouch mount, embossed "CR-10S Pro V2" and "Micro Swiss Direct Extrude" into it to reduce part confusion.

You will have to adjust your x and y probe offset
X = -50mm (50 mm left of nozzle)
Y = -5mm (5 mm in front of nozzle, toward the screen)

Remixed from https://www.thingiverse.com/thing:4893486 

I printed in PETG (ASA would be better) without supports, 3x walls, 0.2mm resolution, 30% infill.

Tags