Passive Camera Stabilizer

This is a passive stabilizer for cameras. It was made mostly to make smooth stable video. Most parts are printed in petg at 0.20mm. The stabilizer model is printed in pla at 0.15mm this is for a little extra give. If the dove tails don't press together without excessive force then boil some water once boiling place the female dove tail into the water for about 5 seconds then press the parts together. After fitting the parts add glue. With the stabilizer if it comes of  the build plate a little stuck together use your plyers to hold the little bars and carefully rotate after its starts to move rotate each part until it feels lose. This then goes into the stabilizer house. The spacers are so a camera almost any size can fit. You only need to use the ones you need. the stabilizer and handle go together with the connecting rod. You will need a 20mm long screw of whatever your camera uses. Finally try and place the center of gravity of your camera directly under the stabilizer. If there are any questions feel free to ask.