Printrbot Simple Metal electronics fan holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
After a board failure in my Printrbot Simple Metal, I replaced my printrboard electronics with a mini-RAMBO card and…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 11
- Makes
- 0
- Views
- 136
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
After a board failure in my Printrbot Simple Metal, I replaced my printrboard electronics with a mini-RAMBO card and the latest version of Marlin Firmware. I hand-made a mounting adapter to fit the mini-RAMBO where the printrboard had fitted, in the space under the printer.
It rapidly became clear that I needed to actively cool the A4988 drivers in the mini-RAMBO card, hence this fan holder. It just clips to the underside of the printer, blowing air upwards over the electronics.
Wire the fan 12v into the 12v input to the board, running it through the extra hole on the fan holder to hold it in place.
Print Settings
Printer Brand:
Printrbot
Printer:
Printrbot Simple Metal
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Filament: Filamentum PLA Green
Notes:
Nothing special here
Fix the fan underneath
No finishing needed. The Printrbot Simple Metal underside is curved, so even with the fan underneath the holder it will clip onto the metal sides of the case, blowing air over the electronics.
Category: 3D Printer Accessories