Pet playpen panel clamp
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement clamp that connects a panel to a wall bracket for the In The Zone Convertible Plastic Pet Gate & Play Pen
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 15
- Makes
- 0
- Views
- 319
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Noncommercial
We misplaced three of the four the brackets that clamp onto the pen panels so that they can connect to the wall brackets. I duplicated the originals in a format that can print without supports. It interfaces smoothly with the existing wall brackets.
One added item is a hold through the center, I use this for a zip tie to provide extra holding power because my dog is a maniac.
The clamps print upside down without supports of any kind. I printed in PLA, overall infill of 70%. However, in prusa slicer I added a cube modifier over the bottom ¾ of the angled support under the “ear” that would otherwise be floating and set infill there to 15% since it is non-structural.