Yokomo YD2SX3 esc wiring stealth mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount plate to mount esc on rear difuser with wiring under neeth right rear out drive.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 53
- Makes
- 0
- Views
- 970
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Mount plate to mount esc on rear difuser with wiring underneath right rear out drive.
This mount allows you to run the power, motor, esc signal and sensor wiring underneath a place and underneath the right rear out drive on the YD2SX3 chassis, so you can have a fairly need wiring solution.
I've used 14awg wiring for power and motor wires, and a 180mm Yokomo sensor wire for the example photos.
Print upside down so where the esc mounts will be on the surface of the printer and the only supports will be under the beveled screw holes and the hump lined up with the out drive.