Keyestudio W5500 Box
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My boss asked for a project box for the Keyestudio W5500, with holes for zip ties and enough space an Arduino hat.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 21
- Makes
- 0
- Views
- 340
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
My boss asked for a project box for the Keyestudio W5500, with holes for zip ties and enough space for a short Arduino hat. The board slides into the grooves on the interior walls and bridge across the top is for wire harness strain relief. The zip tie holes below the board are positioned such that they should just barely avoid running into any major solder joints.
Printing in PETG or PLA should also be sufficient. The W5500, despite its additional features, shouldn't ever get warm enough to cause an issue for either material.
I typically print the model oriented vertically, though doing so affects the SD card slot chamfer quality when using PETG. You could also print the model horizontally, but then you have to deal with bridging on the wire harness arch.