1 / 12
[v2] Prusa i3 MK3 Y-axis belt tensioner
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bear-style y-axis idler holder and belt tensioner for the stock Prusa i3 MK3 frame
- Rating
- 4.714 / 5
- Likes
- 144
- Downloads
- 591
- Makes
- 9
- Views
- 4,568
- Reviews
- 7
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- GNU General Public License v3.0
This is a remix of the y-axis idler mount from the Prusa i3 Bear Upgrade that fits on the stock Prusa i3 MK3 frame.
Installation
- Remove the LCD assembly from the front plate
- Remove the front plate and existing idler mount from the printer
- Screw the new y idler mount onto the front plate using the top and bottom holes
- Drill through the middle hole using a 3mm (or 1/8in) bit to make a new mounting hole in the front plate (deburr if necessary)
- Remove the mount and place the final installation hardware
- Install regular hex nuts into the bottom and middle holes
- Install a nylock nut (nylon side towards the front plate) into the top hole
- Being careful not to lose the nylock nut, pass screws through the front plate into the mount using the bottom and middle holes
- Attach the tensioner to the idler mount using an M3×25mm screw and nylock nut
- If you have a MK3S(+), replace the tensioner under the bed with a MK3 belt clamp
Installation for v1 is similar, but alignment is more difficult and you need to insert the nylock nut into the slot on top.
v2 Update
- Loosen nut tolerances
- Tensioner nut is now held in place by the frame; no need to push it in from the top
Note: the images are of v1, but the process for v2 is similar.
Required Parts
| Original MK3 belt holder | Print this if you have a MK3S(+). Having two tensioners for the same belt may be problematic. |
| Prusa smooth idler tensioner | Print this if you have the stock Prusa idler, 3mm bore with a single bearing. |
| E3D toothed idler tensioner | Print this if you have an E3D 20-toothed idler for 6mm 2GT belts. Toothed idlers have several benefits over smooth idlers (see E3D's description). |
Printing Instructions
Print with 3 or 4 perimeters and at least 20% infill using a 0.4mm nozzle. Although it works either way, I recommend printing this model upside down to put the nice surface finish on top.