Transistor Tester Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a case for a Transistor Tester. This is based on the version provided in Hackerboxes Box #18. An optional knob…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 13
- Makes
- 0
- Views
- 282
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
This is a case for a Transistor Tester. This is based on the version provided in Hackerboxes Box #18. An optional knob is included to compensate for the short amount of the rotary knob sticking out.
Print Settings
Printer Brand:
Prusa
Printer:
Prusa Mk2
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20
Notes:
Print with outside to the print bed to avoid the need of supports.
Note: These STL were exported from Fusion360. Often Fusion will export the file as mm instead of inches. If this occurs, scale uniformly by 2540%.
Post-Printing
Assembly
Lay Transistor Tester in bottom half. Connect three wires to connect probes to the tester. Either solder them to the solder pads or use the ZIF socket. Feed wires through the round hole in the top plate. Lay top plate on top of the base. I used 4-40 Machine Screws, 1 inch long, 4 total, to secure things together. Machine screws go through both halves of the case and the holes in the Transistor Tester. Optional, use a thread locker to keep nuts from screwing off.
Category: Electronics