1 / 1
Canned Cat Food Dispenser
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A dispenser to store stacked cans of cat food
- Rating
- 5 / 5
- Likes
- 76
- Downloads
- 330
- Makes
- 1
- Views
- 2,917
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a small dispenser I designed to dispense cat food. I designed it around the Hills C/D cans, but I imagine it should accommodate most 3.3" wet food cans. The cans must be stacked in opposing directions in order to be able to pull them out.
Should print with supports.
NOTE: The model is a bit taller than the pictured print. I ran out of filament mid-print, but it still held the five cans I designed it for, so I called this “good enough”.
I've also attached the SolveSpace file if anyone wishes to make any modifications.