Printable Hand Vise
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
fully printable hand vise
- Rating
- 4.9 / 5
- Likes
- 246
- Downloads
- 791
- Makes
- 13
- Views
- 3,337
- Reviews
- 10
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
When working with small models sometimes my fingers just are too big. So I made a fully printable hand vise.
Print everything in PLA with a layer height of 0.2mm or lower. Support is not needed. The thread is close to M12 and should work directly after printing. Lubricating the thread is recommended - I am using candle wax for that. If you want, you can re-cut the thread with an M12 tapper, but that should not be necessary.
For the hinges I designed hinge rivets. To install the claws insert the claws and the hinge rivets, heat up a screwdriver and press it on the small end of the rivet. The rivet will melt in place.
Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0
You are not allowed to copy this model to other 3D printing websites without my permission.