AMASS XT30U-F Panel Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wouldn't it be convenient to be able to put a XT30U-F connector on the back of your enclosure? That's what this is for.
- Rating
- 0 / 5
- Likes
- 23
- Downloads
- 240
- Makes
- 1
- Views
- 1,536
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Note: XT30U-F are conventionally power outputs, not inputs. You don't want live pings exposed when the connectors are exposed. So don't use this to power your project. Thanks to niZmo for pointing out this omission.
M3 mounting hardware.
The adapter holds a (real, all bets off on counterfeits) XT30U-F sits flush on the exterior side and 1mm recessed on the interior. I recommend soldering up the connector before seating it in the panel mount. There's 2mm clearance around where the XT30U-M fits so you can use 3D printed caps and such.
The connector has a lip in the back to prevent it from going all the way through, with enough pressure fit that it isn't going to come back out unless you're trying, that said, there's a slot on the back for a dab of superglue if you want to be sure it's permanent.
I printed it using supports.
The design is based off of the AMASS datasheet retrieved from: https://www.tme.eu/Document/3cbfa5cfa544d79584972dd5234a409e/XT30U%20SPEC.pdf except I deviated from the curved edges shown in the datasheet for the 45 degree angles found on actual parts.