ApexDC Long Boi 7" V2

These are parts I've designed/remixed to create the ApexDC "Long Boi" 7inch. 
This mount allows space on the top plate for a larger, Long-Range friendly, battery.


Recommendations:
Use Priline TPU Filament as it is stiffer than brands like Sainsmart and will provide more stability. Or any TPU that is noticeably stiffer than Sainsmart tpu. 
Priline is cheap and easy to print with, so it's a great option. 
(Sainsmart TPU will work, but it will just be a little more bouncy when doing flips on the Pitch axis.)

Run your GPS and Air Unit wires BELOW the Air Unit. The files contain an STL for shims that space the Air Unit up to give room for the wires(The SMA/GPS mount has these shims built in). Doing this provides a clean path/space for the rear battery strap.

Turn your ESC 180 Degrees so your capacitor has room and battery leads come out of the front-top or side.


Print Settings:
*0.16 Layer Height
*100% Infill 
*Print adjustable camera mounts standing straight up with the record button cut-out flat on the print bed. Use support blockers on the M2 mounting FPV cam mounting holes at the top.

*The adjustable mount that slides onto the standoffs requires being printed with a brim otherwise the front may raise off the bed and warp the hole. 

Hardware needed for V2 (Adjustable Mount):
2x M3 25mm knurled Standoffs(Amazon/NewBeeDrone)
4x M3 Counterbore Washers (Amazon/RaceDayQuads/PyroDrone)
4x M3x8mm Hex Bolts (Amazon/Amazon Variety Pack)



Remixes:
Camera mount for the extension plate is a remix of:
https://www.thingiverse.com/thing:4645550

GPS mount is a remix of:
https://www.thingiverse.com/thing:4515525

Lens Protector is a remix from one of these, and I recommend using one of these if you use my camera mount:
https://www.thingiverse.com/thing:4712271

Arm Bumper is a remix of:
https://www.thingiverse.com/thing:4686586