Softsoap Collar Soap Saver

I recently purchased a new Softsoap bottle because the old one was getting seriously gross--even after years of (lots of) cleaning. Lo and behold the corporate scoundrels at Colgate-Palmolive have modified the pump to dispenseway too much soap (wasting it)! I'm not talking, "a little bit more than before" I'm talking, "holy crap that's a lot of soap that just went on to my hand!"

Fight back against the excesses of corporate greed with this simple plastic collar that costs about a tenth of a cent in your filament of choice! Just print it, snap it on, and the bottle will dispense about half as much soap as before (aka, the right amount).

Print instructions

Resolution and infill don't matter. Just print it.

Pro tip: You can scale it on the Z axis to make it taller if you want to save more soap! I found that the amount dispensed is just about right for my (admittedly large) hands but you should know that designing soap savers is a slippery slope! ;)