Camera Mount For The Raise3D E2 3D-printer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A REALLY fast design of a camera mount for an alternative camera for the Raise3D E2.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 24
- Makes
- 0
- Views
- 299
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
The Raise3D E2 printer has a legendary sh$#&" camera. So, inspired by the Raise3D-forums I tested a solution with a new camera that uses the same connector as the old one. So its really easy to connect, and there is no need for software tinkering. All you have to do is to remove the old, attach the mount and mount and connect the new camera.
1. Remove the plastic cover covering the motherboard.
2. Cut the plastic strip holding the cable harness. Be careful not cutting any of the cables.
3. Find the cable for the camera, and re-strip the rest of the harness where it was orignially.
4. Carefully detach the cable connected to the old camera.
5. Install the printed plastic mount (this file)
6. Use some thin machine bolts to mount the camera. Be careful not tightening the bolts to much. It's just to hold the camera in place.
7. Put the plastic cover back on.
8. The camera has focus adjustment, så twist the lens to make your image sharp.
Disclaimer: I take no responsibility if this mod makes your E2 blow up, attack your neighbour or steal your girlfriend.
Camera found on eBay: https://www.ebay.com/itm/254774137570