Pegboard (Metric) - Nut Driver Holders
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.16 – €0.19 net (excluding VAT)
For file: hanger2-metric_02mm_pla_mk3s_14m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.17 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 13.8 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
NOTE : These pegboard organizers are for Metric type pegboard: 22mm spacing between holes 6mm holes thickness approx.
- Rating
- 5 / 5
- Likes
- 15
- Downloads
- 110
- Makes
- 1
- Views
- 940
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Public Domain
NOTE : These pegboard organizers are for Metric type pegboard:
22mm spacing between holes
6mm holes
thickness approx. 4mm
(A separate US pegboard version is also available.)
NOTE 2 : Warning - untested! These files are a variation of the US pegboard version I made for myself. I don't have any Metric pegboard to check these on, but it was a simple modification to make so I thought it might be useful to some people.
These are for 7-piece sets of nut drive holders. "Nut drive holder1" was made for metric nut drivers from Harbor Freight; "Nut driver holder2" is for 3/16" to 1/2" nut drivers from Craftsman.
Not all nut driver sets have identical shaft sizes, so check yours before using these prints. My nut driver sets have the following shaft sizes:
Metric : 10mm, 7.7mm, 7mm, 7mm, 7mm, 5.85mm, 5.85mm
Craftsman : 0.435", 0.435", 0.313", 0.313", 0.313", 0.246", 0.246"
Each holder consists of a main section with insertable pegboard hangers. Each holder can take up to four insertable hangers, but I found that two hangers are sufficient.
The OnShape 3D CAD files for these prints are available here:
Print instructions
For the holder section:
Rotate piece Z by 40 degrees to fit on bed.
Infill: Fill density = 10%
Fill pattern = rectilinear
Top fill pattern = concentric
Bottom fill pattern = concentric
Fill angle = 95 degrees
Perimeters = 3 minimum
For the hanger pieces:
Print on side with a brim. If you use the provided .3mf file it will print both pieces one at a time.