Press Latch Wallet With Cash Clip (Holds 6 Cards)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Minimalist wallet with a press lock card slot and cash clip. Holds 6 cards and cash.
- Rating
- 3.5 / 5
- Likes
- 102
- Downloads
- 312
- Makes
- 1
- Views
- 5,317
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Fashion Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike

EDIT:
A new file for the main wallet body has been uploaded. If you previously had issues with the .stl file, the .3mf may work better.
To use the wallet, you can press down on the spring and the tab over the card opening will lift to let the cards be removed. (see gif above)
This wallet can be fully printed out of PLA. It is designed to be optimally printed with a 0.4 or 0.2mm nozzle, as the thin walls are designed to be printed as either two or four print lines respectively. This helps make nice smooth walls that don't need infill, and give it better flexibility along the layers. The main wallet body should be printed standing up vertically, and may need support under the cutouts on the bottom depending on how good your printer is at overhangs and bridging. The cash clip and locking spring can be printed without support.
To assemble, the cash clip and locking spring slide into a mount on each side, and are held in place by friction and the small plastic nub that goes into the hole in the main body. If the print quality on the mount isn't perfect, it should be easy to clean up with a file or some sand paper. Inserting the clip and spring are intentionally difficult, I wanted the fit to be tight so it wouldn't come loose over time. Over time the spring or clip may wear out, but I have had success in renewing their strength by removing them and lightly warming them for a second with a lighter and bending them a bit. Or, you could just re-print them; they each take only 20 minutes to print.
