Thundershot "Huge Iron" Kit
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Give your BuzzBee Thundershot an old west vibe!
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 33
- Makes
- 0
- Views
- 353
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution
Another Kit for the BuzzBee Thundershot.
This one is modeled after the old Cowboy Revolver, but this Iron isn't just big. It's Huge.
The grip is angled, and in conjunction with a modified hammer attachment, it makes the blaster MUCH easier to one-hand prime. In addition, the design of the muzzle removes a lot of play from the cylinder, giving much greater consistency in FPS.
Also included is a spring spacer. This is placed behind the spring, and slips over the top of the plunger rod. No need to remove the plunger head pin. This not only adds a bit of extra precompression to the spring (more power), but also reduces the amount the plunger tube can slide, which gives a better seal from the plunger tube to the cylinder.
Printing:
PLA
1-3mm Layer Height
10-15% Infill minimum
2+ perimeters
Everything should simply integrate directly with the Thundershot shell, and the new Grip accepts the original screws from the old Grip. The Hammer uses the 4th extra screw from the original grip.
You MUST print the Spring Spacer at or below 0.2mm layer height, as the tolerances are very tight, for where the spacer needs to fit.