Angled spacer for Kitronik :MOVE mini MK2 buggy
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The Kitronik :MOVE mini MK2 buggy is lovely, but its default setup assumes you're using a very slim USB cable. This…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 17
- Makes
- 0
- Views
- 189
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
The Kitronik :MOVE mini MK2 buggy is lovely, but its default setup assumes you're using a very slim USB cable. This replacement spacer bar angles the micro:bit slight further out from the Kitronik Servo Lite board, allowing the use of most (?) micro USB cables.
Note that the spacer bar can't be seen in the photo
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.1 mm
Infill:
15%
Filament: eSun PETG Transparent Green Post-Printing =============
Installation
Place the spacer between the Servo Lite Board and the micro:bit with the slightly narrower side facing down, then secure the assembly with the screws provided with the :MOVE mini kit.
Category: Robotics