1 / 1
Ski boot dryer with 12VDC FAN 92x92mm
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
During winter fun in the snow, shoes often get wet.
- Rating
- 4 / 5
- Likes
- 63
- Downloads
- 189
- Makes
- 1
- Views
- 3,467
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Winter Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
During winter fun in the snow, shoes often get wet. That's why I designed and built a 3D printer dryer for two pair of shoes with 12VDC fan 92x92mm and flexible corrugated hose diameter 32mm. Can be used in a car or caravan with 12VDC board voltage ...
Print instructions
Good print result is from the PLA Prusament.Slicer properties: 2 perimeters, layer height 0,2mm, min. 15% infill, 3 top/bottom layers, no supports needed but need bridge perimeters detection. For assembly use 4 screws M3 or M4 with nuts long according to the fan width (40mm is suitable for 25mm).