101Hero Controller Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I took the top mount and made some adjustments for a sturdier fit. 1) Inside the notched end is 20mm to prevent the…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 8
- Makes
- 0
- Views
- 106
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
I took the top mount and made some adjustments for a sturdier fit.
Inside the notched end is 20mm to prevent the bracket from sliding
Two corners of the inner fill are curved so the bracket rotates in and locks.
Print two of these to securely mount the controller box to any of the towers.
Note: The bracket will only turn clockwise. For the bottom bracket, the fingers of the bracket should be facing 9 o'clock. For the top bracket, the fingers should be facing 3 o'clock.
Version 2 has thicker sides to help prevent breaking if control box is bumped hard.
Print Settings
Printer:
101Hero
Rafts:
No
Supports:
No
Resolution:
0.18mm
Infill:
20%
Post-Printing
Installation
Hold bracket sideways and insert into the opening of the tower fitting the legs of the bracket around the tower wall.
Insert the bottom bracket in the lower tower slot, slide down and rest the controller box in the bracket with the power switch facing up. Insert the top bracket in the upper tower slot, rotate it and slide it down to rest on top of the controller.Note: The bracket will only turn clockwise. For the bottom bracket, the fingers of the bracket should be facing 9 o'clock. For the top bracket, the fingers should be facing 3 o'clock.
Category: 3D Printer Accessories