1 / 2
PET Bottle Brake Bleeder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
PET Bottle Cap to build a brake bleeder as seen on ChrisFix
- Rating
- 5 / 5
- Likes
- 208
- Downloads
- 787
- Makes
- 3
- Views
- 3,333
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
PET Bottle Cap Adapter to build a brake bleeder as seen on ChrisFix. Prints without supports in under 30 minutes. This is ONLY meant to prevent the tube from sliding in and out of the bottle, not as spill prevention. The cap does not hold water (or brakefluid)!
BOM
- <1m windshield washer tubing (4.5 - 5mm inner diameter)
Printing
PET-G is probably recommended, but PLA works (at least once). Use 2 Perimiters, 0% Infill, and enable Bridge Settings.
Remixed from a thing on Thingiverse