LED-strip mount and diffuser
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.46 – €0.56 net (excluding VAT)
For file: L Corner 2_0.15mm_PLA_MK3S_34m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.51 excluding VAT (range midpoint).
- Weight reported by the author
- 5 g
- Print time reported by the author
- 34.2 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Easy mount for LED strips up to 10mm width.
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 82
- Makes
- 0
- Views
- 606
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a standardized version of my LED diffuser I built for my enclosure using transparent PLA . It is 240mm long and has holes for M3 countersunk screws. It is for LED strips up to 10mm width.
If you need another length just add a modifier as a negative volume in prusa slicer and cut the length as needed.
There are two versions. One is flat, the other is with a 45° angle which I used for the sides of the enclosure