CM4 IO Board Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Easy to print Raspberry Pi CM4IO Board Stand
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 72
- Makes
- 2
- Views
- 657
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
This minimalist stand is easy to print and lifts your IO Board off the table surface, avoiding damaging your board.
Included in the design:
2 Support Plates Models - each model fits a specific side of the IO Board
1 Side Feet Model - feet are reversible, so print 2 of these
Suggested Print Settings:
Material: PLA or PETG
Nozzle: 0.4mm
Layer Height: 0.2mm
Infill: 15%
Place the hex nut slots facing up on the build plate.
Other items you will need:
(4) M3x8mm screws - to attach the feet to the support plates
(4) M2.5x8mm screws - to attach the CM4 IO Board to the support plates
(4) M2.5 Hex Nuts - to secure the M2.5 screws