Sy's Peglock - Pegboard Bridge
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 2x2 plate designed to connect pegboards together for my 1" locking pegboard system.
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 144
- Makes
- 1
- Views
- 1,975
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
This plate is designed to connect together multiple pegboards. This adds additional strength for large pegboards that only have support around the edges like the one pictured. The plate in the photos has a school logo on it, but I've only included the blank plate for legal reasons. Add your own logo if you would like!
This model uses my locking pegboard mount system for 1" standard pegboards. Magnet holes (if present) are designed for 10mm diameter, 3mm thick magnets. “Board Attachment” parts are universal to all models. Print with 3 perimeters and 0.3mm or thinner layer height for best results.
To mount, fold the "Board Attachment" model, insert it into the pegboard so the triangular surface points up, then slide the mount over top. With a bit of force it should fully lock into place. If needed, use a small mallet or similar to mount/remove.