Seasoning/Gravy Packet Holder Lite
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.27 – €2.77 net (excluding VAT)
For file: Seasoning-Packet-Holder-Lite.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.52 excluding VAT (range midpoint).
- Weight reported by the author
- 32 g
- Print time reported by the author
- 2.5 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A simple design for holding 8 standard seasoning/gravy packets. Prints fast and saves plastic.
- Rating
- 5 / 5
- Likes
- 55
- Downloads
- 485
- Makes
- 6
- Views
- 1,438
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Public Domain
I finally got tired of my seasoning packets going all over the place in my cupboard so I decided to print a holder for them. All of the existing designs I could find online were either total overkill to hold some packets or used way too much plastic/time to print (or both). So I decided to make my own “lite” holder to save resources that was just sturdy enough and big enough to hold the packets together, not survive the apocalypse.
To get the cleanest, fastest print I suggest doing a 0.5-0.52mm wall line width. This way it just prints the inner and outer walls with no weird gaps to fill. This also means it prints with very few retractions and is almost like a vase mode print. I recommend setting the seam to one of the back corners for best results.
This holds approximately 8 standard packets (7 are pictured). Depending on how full they are, you might need to redistribute the powder a bit to comfortably fit all 8 when first putting them in if you don't want to bow the walls out too much.