USB Cable Winder Stackable
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Minor modifications : 45° angle to facilitate printing of the model in the lower part and new design.
- Rating
- 4.583 / 5
- Likes
- 147
- Downloads
- 1,476
- Makes
- 14
- Views
- 6,847
- Reviews
- 12
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Author : TinkrMakr
I changed the angle to 45° because I read in the comments that some people had problems to properly print the lower part of the model. I had the same problem, but I don’t think it came from the angle of the model but from the fact that I was printing the PETG with too low a temperature. I have an MK3S with the MMU2S, and when I print Prusament PETG in single material the nozzle temperature is set to 250° whereas when I use multi material with the same material the nozzle temperature is set to 230°? And that’s why I had printing quality problems on the lower part of the model. I realized by printing the temperature tower, below 235° the quality is not there. I will soon relaunch a print of the model with the original 35° angle using the correct print temperature
Thank to TinkrMakr for his work and sharing.
Added 45° angle knurled version